cross-posted from: https://lemmus.org/post/26133267

Be careful if you attempt this, you’re working with 240v electronics.

A few months ago I noticed my EVSE started buzzing really loudly every time I would plug in to charge. A few days after that it stopped charging entirely. It’s a Clippercreek, that is 8+ years old, I can’t complain too much but I can’t exactly afford $300-ish for a replacement, so I decided to try to replace the relay myself.

I opened it up and found that the big problem with doing this is that the relay has 6 large contact studs that are all soldered into the circuit board. I can only heat one up with a soldering iron at a time, and the one cannot pull out because the other five are still holding the relay onto the board.

So, I got a hacksaw blade and slid it behind the relay and cut off each leg one by one. You have to be very careful doing this to avoid cutting anything else, but I did get them all cut off without much damage to any of the other circuitry. After that I can melt the solder and remove each stud one by one.

I bought the exact brand/model relay for $40 off Amazon. Probably could have got it cheaper elsewhere if I was willing to wait.

The next problem is that all those holes in the circuit board are full of solder that block the new relay from going in. I found that there is such a thing as “desoldering wick” which I used to absorb the melted solder out one by one. Then the new relay could be inserted and the six studs soldered in one by one.

And it works!

  • partial_accumen@lemmy.world
    link
    fedilink
    arrow-up
    3
    ·
    edit-2
    6 days ago

    Nicely done! Clippercreek chargers have a really good reputation, but I suppose even after 8 years some repair may be expected.

    If you expect to have this need in the future, I’d also recommend getting a cheap solder sucker desoldering tool. Like this one:

    They cost about $5. Where you used solder wick, you’d use this first and get most if not all of the old solder out of the holes. You may have to do a final cleanup with solder wick, but it means you don’t consume nearly as much of it.

    Nice save of your vehicle charger!