Fake fiberglass rock?
From Usenet to MySpace to Facebook to Reddit to Lemmy
Fake fiberglass rock?
North Fla resident here, where’s the beach you’re talking about?
You’re making my point for me. If you’re super generous about paying this man for all his trouble, loss of freedom, court costs, etc. (and we should be) …and then you double that for good measure… and then you double THAT for punitive purposes (and yes we should)… You still are far short of $175k.
I’m only bringing it up because it’s our money as taxpayers. The ACLU should not be another piggy at the public trough.
How weird. Archive did some long display of loading resources and then showed me the correct article…but apparently the “share” link on it was wrong. Crazy
Who was harmed here to the tune of $175k? The ACLU should have settled for something much less.
Love my Allbirds for just this reason, I machine wash them about every 2 months or so
Did you miss the part where the other companies were owned by Coca-Cola? And how they magically reproduced Coke’s flavor perfectly?
I have to say I think he really succeeded in one area: growing the next generation of Hamas.
Voltage and a pin out would be cooler
When do we turn our disgust into our boycott?
Banks this dumb can’t hold my money
A small man screaming “I’m still relevant!” as the doors begin to close on him
Okay I want a broke down one of these, an crate electric motor, and a lifepo4 battery pack
It sounds awesome. First I would explain how difficult it is for low voltage to cause fires. If that doesn’t work, maybe make a demo of a catastrophic failure (dead short) of your 5v brick, maybe he’ll see that doesn’t cause a fire. Or finally maybe encase the power brick and control circuitry in a metal container?
Two years is not enough for attempted rape.
Where does Latin fit in?
Forget the chemicals, you’d need to be an expert to insure a good finish after strippers. Sanding should do nicely and not be too hard - it’s also one of the steps kids can help with. From the looks of it sanding by hand or with a jitterbug should be enough. Sand with the grain. Maybe 120-150 grit until it’s uniform and then 220. Use a tack rag to get the dust off. Then stain if you want and then the poly, at least 3 coats with a very light sanding between them - follow the instructions on the can.
Take off eh