Did you notice a difference in print speed when you slowed down? As this is a small print, it could already be as slow as it will be due to minimum layer times.
It could also be that the nozzle spends too much close to the print. What happens if you print 2 or 3 of them?
This is typically more of an issue with PC where you don’t have a part cooling fan running, but maybe it’s the case here too?
Definitely doesn’t sound like an issue with Tor Browser in Strict Mode. /s
The simple fact that buying a $300 device and to “not expect software updates” is not considered a scam is hilarious to me.
If the point is to monitor the other divers’ cylinder pressure, I believe there’s only the Garmin transmitters that have sufficient range for that (and even then, it’s tricky). Most transmitters will top out around 1-2m range, whereas the Garmin transmitters can have a range up to 10m (in ideal, line-of-sight conditions). I believe you can have up to 4-5 transmitters paired with a computer.
I would recommend teaching everyone good habits and have them monitoring their own pressure, but that’s just me.
Interesting that the extra 10° makes such a difference for ASA and ABS.
I recently started printing with ASA in my enclosed MK4. I might have to try this.
Soit tout le monde a un vote, soit personne n’en a. Limiter la participation c’est créer des non-citoyens, et on a vu ce que ça donne.
Là où il faut intervenir c’est sur la participation. 51% à l’échelle européenne. 51.5% en France. La Belgique fait la fière avec ses 90% de participation, mais ça ne suffit pas. En Croatie 4 personnes sur cinq se sont abstenues. Bon nombre de pays où c’est 2 sur 3.
As far as I know the 1DXIII is still being produced, nearly 4 and a half years after its launch.
Single lens reflexes have one massive advantage: the sensor is not being used while you’re composing or idle, which means the sensor doesn’t heat up as much. Hot sensors generate noise, which you then have to compensate for (by doing an equal exposure with the shutter closed to remove the hot pixels).
But mirrorless is faster, cheaper to produce, smaller. It’s inevitable that DSLRs will soon be a relic of the past. But they won’t be for a while: 30% of the enthusiast market in 2022 was still DSLRs.
Perpignan est géologiquement dans une cuve de pierre, avec très peu d’entrées naturelles. Les POs n’ont que 40% du terrain qui est “sédimentaire”, et qui peut donc absorber l’eau de pluie. L’Agly, le Réart, la Tet et le Tech sont régulièrement a sec, je me souviens faire du camping dans le Réart il y a 20 ans.
La surface sédimentaire est très argileuse, ce qui veut dire que c’est un sol qui est incapable d’absorber de l’eau. Quand c’est sec, rien ne pénètre, et quand c’est saturé, rien ne pénètre. L’eau de pluie finit dans la Méditerranée.
Si tu superposes la carte page 19 du PDF et la carte page 16, tu vois que la majorité du terrain qui n’est pas de la roche pure c’est de l’argile. RIP.
It could be a case of too much cooling, while simultaneously being too much heat.
If you’re blowing so much air that the filament instantly solidifies when it leaves the nozzle, it’s not going to bond with anything else. It’s also interesting that the first layers are fine (when the part cooling fan is typically not running), but problems start when the part cooling fan turns on.
Have you tried without part cooling at all? Another thing is that your part cooling might be cooling down the tip of the nozzle, causing tiny partial clogs, which are cleared every so often by friction.